{"id":133519,"date":"2024-04-09T06:03:30","date_gmt":"2024-04-09T13:03:30","guid":{"rendered":"https:\/\/www.stevenrhine.com\/?p=133519"},"modified":"2026-04-25T19:36:03","modified_gmt":"2026-04-26T02:36:03","slug":"xeltek-superpro-7000-ex-to-gx-adapter-converter","status":"publish","type":"post","link":"https:\/\/www.stevenrhine.com\/?p=133519","title":{"rendered":"Xeltek Superpro 7000 EX to GX Adapter Converter Project!"},"content":{"rendered":"

Here you will Find Info on the EX to GX Adapter Converter For The Xeltek Superpro 7000<\/p>\n

The EX to GX converter For the Xeltek Superpro 700 was a little bit of a challenge due to the slight differences in pinouts between the Superpro 7000 and 7500 going from 1.0mm\u00a0 pitch to 1.27mm pitch but I got it routed out after dozens of tries.<\/p>\n

The commonly available Hirose FX2-100P-1.27SV(71) connectors are for the top of the board, with the exception of the Oupiin connectors mentioned earlier on the bottom, which are now obsolete. To resolve this issue, one must either source a donor adapter or replace the connector on the SK7K-GND Board with another 1.00mm board-to-board connector. Alternatively, one could try using 1.0mm pin pitch male\/female headers is a viable solution they are used on other later of the broad stack.<\/p>\n

Despite the obstacle posed by the obsolete connectors, I am actively searching for a suitable replacement to ensure the continued functionality of the Superpro 7000.<\/p>\n

\u00a0<\/span><\/p>\n

\"\"<\/a> \"\"<\/a>
\nPrototype Boards are in Production and Should be here in About 2 Weeks.
\n\"\"<\/a><\/p>\n

Production Progress March 05\/2025 1:00AM Check.
\n\"\"<\/a><\/p>\n

The Prototype Boards Arrive… Ideas Become Reality.<\/p>\n